Sometimes the drive cable stretches (from the handle to the trans) To check the belts and tension you remove the cover (usually plastic) in the middle of the snow thrower to look at the belts.
The most common cause of this is the drive belt is worn or broken.
Hope This Helps Don Posted on Dec 09, 2009. By the time you try starting it again the fuel bowl is filled again and the whole thing starts all over. If this does not solve the problem then the only other thing I can think of is the needle valve is partially pluged, at startup the fuel bowl is full and the engine startsbut after starting the fuel bowl runs low on fuel as it is not filling fast enough and the engine stalls. 81 Answers SOURCE: it sounds to me like either the oil pressure switch is being plugged after startup and causint the engine to quit then the plug settles until you start it again and it plugs again easiest way to test is to take the swith and remove the wire to it and see if the engine starts and keeps running, if so then replace the old pressure switch.I will try to get a local handyman to fix it or else but a. The auger spins slowly until it hits snow and then stops- The discharge fan continues to spin fast. The gear transfer case between the augers must be broke. SOURCE: on my two stage snow blower-main auger stops turning. Mtd Snowflite 10 28 Manual Transfer 9,0/10 613votes
0 kommentar(er)
